![]() ![]() Plaster of paris also has a very short working time (about 10 minutes), so don't mix up too much at a time.ĭrywall compound will probably match almost as well as plaster of paris, and its available in mixes that are easier to work with (20 minute set time, several hour set time, etc.). These are nailed horizontally to the vertical upright timbers which act as the wall framework. Laths are strips of wood with measurements of about 6 mm by 25 mm or 1 by 1/4 inches. 7 Maintenance and upkeep for hanging objects on lath and plaster walls. You can use drywall tape on the edges where it meets the old plaster, but may want to score the old plaster so that you can embed the tape a little. This technique was used for non-load-bearing internal walls and ceilings as pictured below. 6 Alternative methods for hanging objects on lath and plaster walls. This is one case where a little is better than a lot, because you can always add more layers. ![]() Plaster of paris will dry very hard, so gradually layer it in to minimize the need for sanding. ![]() The old plaster is probably fairly thick, so you could also screw or glue in some 1/4" or 1/2" drywall first to fill the void, and then use plaster or drywall compound on top of it to completely fill in the area. Since plaster is considered a higher quality material than drywall. If you still have the wood lathe to fill the hole and just need plaster, you can use plaster of paris (most like your old plaster), or something like versabond drywall compound to fill the areas. Replacing plaster walls with drywall will cost well over 10000 for a 2000 square foot home. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |